Your Raspberry Pi needs to be connected to the internet to install the software but not needed to run ScratchGPIO. How to get a Raspberry Pi to control the GPIO Pins using Scratch. Blue italics are extra information for those who like to understand things a bit more – Pink italics are for the more advanced users and can be completely ignored by normal users. Minimum Requirements – a Raspberry Pi with Raspbian installed (a working internet connection is very handy but not required) a breadboard, some Light Emitting Diodes (LEDs), some resistors and some wire connectors. This post is intended to make it as Simple as Pi to get up and running and make your Raspberry Pi control some lights and small motors and to respond to switches and sensors. Please use the new Version 5 This post is being left here as some books refer to the older version Scratch Controlling the GPIO Pins on a Raspberry Pi This post refers to an older version of ScratchGPIO
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |